This dataset contains orthoimagery as part of the contract to provide new natural color digital aerial imagery with airborne GPS-IMU control and ground surveyed control to develop and support 4 band (RGBIR) 8 bit 12 inch pixel resolution of North region East State Plane Zone of New York, including St. Lawrence County. An East-West flight line orientation was planned and flown for the North Area. The area was planned and flown with Keystone's Aerial Survey's Ultracam Eagle digital mapping cameras UCE-50617043, UCE-00817310, and UCE-50319383 equipped with flight navigation systems and airborne GPS and inertial measurement units flown at an approximate altitude of 15108 feet above mean ground elevation. An image footprint of 20010 x 13080 pixels was captured for the UC Eagle. A total of 49 flight lines and 3976 exposures were captured for the North region. Imagery was captured between April 28th and May 7th, 2014, with a sun angle exceeding 30 degrees. Images were broken into blocks, which were divided into sub-blocks for aerial triangulation (AT) processing. Automatic Point Measurement (APM) was run on the images to measure terrain points to tie the images together. The imagery was then used in the AT process in Socet Set/Orima where tie point measurement was performed and independent ground control points and airborne GPS were introduced to further refine the data. The APM and Airborne GPS/IMU data covering the three Counties of the East State Plane Zone of the North Area (St. Lawrence,St. Lawrence, and St. Lawrence Counties) and a small segment of Lewis County were copied and used exclusively to produce a separate aerotriangulation solultion. DEM data acquired by the USGS and a small portion in northeastern St. Lawrence County was modified by Axis GeoSpatial then applied in the orthorectification process to produce 4-band RGB-IR digital orthoimages free of distortion. All ortho rectified images were reviewed for consistency with project requirements before the mosaicking and tiling process. Bridge distortions and other errors were corrected at this stage. As part of the mosaicking and tiling process in OrthoVista, all images were adjusted for color and radiometric differences over large blocks. The individual tiles produced were then inspected in a final QA/QC process for overall image quality with all undesirable artifacts and errors corrected before delivery. The end product for St. Lawrence County was 13956 seamless 8-bit 4-band RGB-IR image tiles, 2000 by 3000 feet wide in TIFF/TFW format. Imagery was also delivered in JP2/J2W format at a 10:1 compression ratio.